In most cases a window that drops is due to the shoes coming off of the pivot bar. This is easily fixed following the instructions below:
- Use a flat blade screw driver and insert it into the metal part of the shoe that has a “U” shape grove in it. The upright “U” is the locked position for the shoe. In the next step we will be “unlocking” the shoe to allow for adjustment.
- Using a fair amount of force, turn the screw driver clock wise until the “U” turns into a “C” shape. This is the unlocked position shown in the picture to the right.Note: The shoe is spring loaded. Make sure to hold the shoe so that it doesn’t go all of the way up. You may need an additional person to help.
- Bring the shoe up 3″-4″ and twist the screw driver back counter clockwise to bring the grove back to the “U” or locked position. You can now remove the flat head screw driver that was holding the shoe as shown in picture 3.
- Now bring the sash down to the level of the shoe.
- With the tilt latch, tilt the window open as shown in the picture 4. Please ensure that the sash is level to the floor.
- Press on the window near the shoe to force it into the shoe.
- Close the sash.
- Pull the sash UPWARD to ensure the shoe has engaged. If the shoe has engaged, you will need to repeat step 4 through 7. If the shoe is properly connected you will not see it any longer and the window will function properly.Note: Do not remove sash unless absolutely necessary.
See other Repairs »